For reasons which will be explained later, I’m going to detail the remainder of the build process in this single post. Apologies for the lack of photos.
Right Arm - I was a bit too tired when I assembled the right arm, and when I get tired, I tend to do things fast and sloppy. Some of the pieces became warped at the cut points, though luckily most of these pieces were part of the exoskeleton, meaning they’d be concealed under the outer armor. The rest of the assembly process went smoothly, which was a welcome state of affairs after the crisis I had with the leg joint.
My stickering got a lot better with the right arm. I found myself coming up with a process; I would remove the sticker with the hobby knife, transfer it to the nail care stick, and apply to the model. I then used the stick to reposition and set it in place. All told, the stickering wasn’t perfect (the larger decals on the shoulder mounted shield are a little off angle), but it was still a dramatic (and noticeable) improvement.
I did the entire arm in a single night, spending a little under three hours.